Thermo Scientific Micro-Tech 9101, Reference Manual

Page: 24 / 329

Introduction
Important Safety Information
1-6 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
WARNING.
All panels covering the electronics must be in place and
tight before wash down procedures. Damage to the electronics could
result from water, moisture, or contamination in the electronics
housing.

Please read the following warnings and cautions, when working with
incoming power to the Micro-Tech or its associated systems.
CAUTION.
Do not connect power until you have read and understood
this entire section. Improper connection may result in damage to your
integrator.

WARNING.
All wiring must be in accordance with standards (IEC,
EN) national and local codes (NEC, VDE, and so forth) outline
provisions, for safely installing electrical equipment. Installation must
comply with specifications regarding wire types, conductor sizes, branch
circuit protection, and disconnect devices. Failure to do so may result in
personal injury and/or equipment damage.

WARNING.
Ground impedance must conform to the requirements of
national and local industrial safety regulations and/or electrical codes.
The integrity of all ground connections should be periodically checked.
For installations within a cabinet, a single safety ground-point or ground
bus-bar connected directly to building steel should be used. All circuits
including the AC input ground conductor should be grounded
independently and directly to this point/bar. Grounding all enclosures
and conduits is strongly recommended.

CAUTION.
Verify that the input voltage is correct with an AC
voltmeter before you connect it to the integrator.

CAUTION.
Earth ground must be provided to the integrator. Do not
use conduit to provide this ground.

Incoming Power
Safety