Thermo Scientific Micro-Tech 9101, Reference Manual

Page: 25 / 329

Introduction
Hardware Installation
Thermo Fisher Scientific Micro-Tech 9101/9201 Reference Manual, Rev J 1-7
CAUTION.
A readily accessible disconnect device (maximum 20 amp)
must be incorporated in the field wiring. This disconnect device should
be within easy reach of the operator and must be marked as the
disconnecting device for the equipment.

The Micro-Tech may cause radio interference if used in a residential or
domestic environment. The installer is required to take measures to
prevent interference, in addition to the essential requirements for CE
compliance provided in this manual, if necessary.
Conformity of the Micro-Tech with CE/EMC requirements does not
guarantee an entire machine or installation complies with CE/EMC
requirements.
This section tells you how to complete the hardware installation for your
Micro-Tech. Please go to the appropriate section, depending on which
model of Micro-Tech you purchased (field-mounted or panel-mounted).
Before installing the Micro-Tech, please read the following important
safety information about wiring up the Micro-Tech.

Ensure power is OFF at the main disconnect.

Do not route load-cell and signal cables in the same conduit with
power cables or any large source of electrical noise.

Earth ground all enclosures and conduits. A ground connection
between all conduits is required.

Connect the shields only where shown.

Check that all wires are tight in their connections.

Never use a “megger” to check the wiring.

A readily accessible disconnect device must be incorporated in the
field wiring. This disconnect should be within easy reach of the
EMC Instructions
Hardware
Installation
Important Wiring
and Safety
Information