Thermo Scientific Micro-Tech 9101, Reference Manual

Page: 186 / 329

B-14 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
Parameter Selection Description
Press Start to begin Weight
calibration
AUTO SPAN Weights START, EXIT
Apply weights then press START
AUTO SPAN Weights START, EXIT Note: Only available if
LOAD WTS output was
selected in I/O Definition
Scroll.
Press START to load the test weights
AUTO SPAN Weights START, EXIT
Run belt, then press START
Remove Weight before returning to
normal operation! RUN, MENU
AUTOSPAN COMPLETE EXIT, FACTOR, REPEAT Note: Only available if
material calibration is done
before and the current
simulated load method has
no material factor installed.
Error %
Unfactored Calcon
XXXX Matl FACTOR YES, NO, ADV
XXXX = R-CAL, CHAINS,
WTS Note: Only available if
material calibration is done
before and the current
simulated load method has
no material factor installed.
New factor ____%
Change factor?
XXXX Matl FACTOR RUN, MENU, REPEAT
XXXX = R-CAL, CHAINS,
WTS Note: Only available if
material calibration is done
before and the current
simulated load method has
no material factor installed.
Old factor %
New factor %
MANUAL SPAN EDIT, EXIT
Rate
Span #