DOCUMENT No.:
REVISION: 1.2
DATE: 2014/11/10
DC-MAM-001-X-C-2
Page 284
PROCEDURE (SWITCH)
1.
Open the instrument panel (refer to paragraph 7.2).
2.
The electrical wiring connections from the switch connections (1). Note (or mark) the
placement / connection of the wires. Wires must be reconnected to the replacement switch in
the same sense / order.
3.
Undo the front nut (2) securing the switch to the instrument panel and remove the switch.
4.
Adjust the rear nut (3) on the replacement switch so that the switch body will be the correct
distance behind the instrument panel when fitted.
5.
Ensure that the switch is inserted correct side up. Align the switch body vertically and secure
with the front nut (3). Do not over tighten. PLEASE NOTE THAT IN CASES WHERE THE
IGNITION (MAGNETO) SWITCHES ARE SEPARATE FROM THE KEY SWITCH, THE
SWITCHES ARE MOUNTED UPSIDE DOWN, SO THAT THE IGNITION CIRCUITS ARE
GROUNDED WHEN THE SWITCH LEVER IS DOWN.
6.
Reattach the wires to the switch connecting terminals, in the same order that they were fitted to
the removed switch.
8.
Inspect for security of attachment and correct connection.
9.
Apply power and test for correct operation.
10.
Apply thread locking sealant to the instrument panel mount screws and close the instrument
panel.
1
5
1
1
5
1
2
5
1
3
5
1
Summary of Contents for Sling 4
Page 1: ......
