DOCUMENT No.:
REVISION: 1.2
DATE: 2014/11/10
DC-MAM-001-X-C-2
Page 260
PROCEDURE (REMOVAL)
Retain any bolts, nuts (except lock-nuts) spacers, screws and washers (with the exception of lock-
washers) for reassembly.
1. Remove the rear seat (refer to paragraph 4.3.2.2).
2. Undo the screws retaining the connector (1) to the sensor (2) and disconnect the connector.
3. Undo the four screws (3) retaining the sensor to the plate (4) and remove the unit.
4. Alternatively, mark the location of the sensor / foam mounting block(s) footprint (for later
replacement in the same location) and tear the unit (attached to plate) from the foam (5).
Clean foam / adhesive residue from the cabin floor.
PROCEDURE (INSTALLATION)
1.
Reverse the above procedure (removal), paying close attention to the following:
Inspect the mounting screws for damage before fitting. Replace if necessary.
2.
Inspect for alignment, security of attachment and proper connector attachment before
replacing the rear seat.
1
2
3
3
4
3
4
4
2
5
3
3
3
3
Summary of Contents for Sling 4
Page 1: ......
