DOCUMENT No.:
REVISION: 1.2
DATE: 2014/11/10
DC-MAM-001-X-C-2
Page 106
PROCEDURE (INSTALLATION)
1.
Reverse the above procedure (removal), paying close attention to the following:
Inspect all bolts, nuts and screws for damage. Replace if necessary.
Do not reuse lock-nuts. Fit new.
Tighten the lock-nut on the bolt through the elevator pushrod rod-end bearing
sufficiently, observe the correct placement of washers and note that the bolt is installed
with its head facing to the port side of the aircraft.
Figure 24: Elevator pushrod to elevator connection.
A AN4-12A bolt
B AN4 lock-nut (Nyloc)
C AN4 washer (1.6 mm / 0.0
63”)
Refer to paragraph 16 for hardware
designations
A
B
C
Summary of Contents for Sling 4
Page 1: ......
