DOCUMENT No.:
REVISION: 1.2
DATE: 2014/11/10
DC-MAM-001-X-C-2
Page 262
PROCEDURE (REMOVAL)
1.
Remove the centre console rear inspection panel (for pilot and co-pilot sockets).
2.
Undo the nut retaining the socket to the mounting plate and pull the socket from the
plate.
3.
Remove the heat shrink on the wire connections and desolder the wire connections.
PROCEDURE (INSTALLATION)
Refer to paragraph 13.10 for the wiring connections / information for each socket / headphone
position.
1. Reverse the above procedure (removal) for installation, paying close attention to the following:
Observe the correct washer / insulator placement (refer to Figure 61).
Shrink the heat shrink with a suitable heat source (e.g. a heat gun). Do not burn / melt
the heat shrink.
Figure 61: Headphone socket installation.
MICROPHONE SOCKET
(ID OF SOCKET: 5.25 mm)
INSULATOR
EXTENDS
THROUGH
THE
MOUNTING HOLE, SUCH THAT NO METAL PART
OF SOCKET IS IN CONTACT WITH METAL OF
MOUNTING PLATE.
HEADPHONE SPEAKER SOCKET
(ID OF SOCKET: 6.35 mm)
FIBREGLASS WASHER
STAINLESS STEEL WASHER
Summary of Contents for Sling 4
Page 1: ......
