DOCUMENT No.:
REVISION: 1.2
DATE: 2014/11/10
DC-MAM-001-X-C-2
Page 112
PROCEDURE (REMOVAL)
1.
Remove the elevator trim motor inspection cover (1) (under the port elevator) by unscrewing
the button head screws (2).
2.
Remove the heat shrink (3) from the trim motor wiring (4) and desolder the wires. Mark the
white wire (motor side) connected to the black wire (aircraft side), to ease later reconnection.
3.
Remove the split pin from the trim tab pushrod connected to the motor, push out the pin and
washer and disconnect the pushrod from the servo.
4.
Unscrew the four button head screws (5) retaining the trim tab motor and remove the motor
from inside the elevator.
1
1
3
1
3
1
4
3
1
2
1
2
1
1
1
3
1
2
1
5
1
Note that this wire (orange / white) is connected to the yellow wire (on
the aircraft side) for the MGL SP10 trim system. Refer to the
connection table under
PROCEDURE (INSTALLATION) below.
Summary of Contents for Sling 4
Page 1: ......