DOCUMENT No.:
REVISION: 1.2
DATE: 2014/11/10
DC-MAM-001-X-C-2
Page 105
PROCEDURE (REMOVAL)
Retain any bolts, nuts (except lock-nuts) spacers, screws and washers (with the exception of lock-
washers) for reassembly.
1.
Remove the vertical stabiliser (refer to paragraph 4.2.2.3).
2.
Support the elevator and disconnect the elevator pushrod from the elevator control horn
(located inside the rear fuselage tail cone). The pushrod rod-end bearing is accessed through
the two small round access holes on the left and right sides of the rear fuselage tail cone.
3.
Support the elevator and loosen and remove the bolts from the elevator hinges.
4.
Carefully and slowly pull the elevator free from the hinges and horizontal stabiliser, until the
trim tab motor cable plug connection is exposed. Disconnect the plug.
Summary of Contents for Sling 4
Page 1: ......
