Symantec Veritas Cluster Server One, Installation Manual

Page: 50 / 210

50 Installing and configuring the VCS One Policy Master
Configuring the Policy Master
4 Do one of the following:
5 For each unique virtual IP address, enter the NIC. For example, enter the
following:
■ (On Linux)
eth0
■ (On Solaris x64)
bge0
You are prompted to specify if you want to use the same NIC for all Policy
Master systems.
6 At the all nodes prompt, do one of the following:
■ If you want to use the same NIC on all Policy Master systems, type
y
.
■ If you want to use different NICs on the different Policy Master
systems, type
n
. Then specify a NIC for each system.
7 For each unique virtual IP address, enter the netmask. For example, enter
the following:
255.255.248.0
.
8 At the disaster recovery configuration verification prompt, verify that the
virtual IP address, NIC, and netmask are correct. Enter the following:
y
.
Configuring disaster recovery after you install VCS One
Follow these steps to configure disaster recovery after you install and configure
VCS One.
To configure disaster recovery after installing and configuring VCS One
1 Launch the VCS One disaster recovery installer. Enter the following:
# ./installvcsonepm -configuredr
2 Enter the name of the system on which you want to configure disaster
recovery. For example, enter the following:
sys1
.
3 Follow the disaster recovery installation steps.
See: “ Configuring disaster recovery as part of the installation and
configuration process ” on page 49.
4 Verify that the disaster recovery service group is online. Enter the following:
# /opt/VRTSvcsone/bin/hagrp -state
If the virtual IP address is already configured, and you see the
disaster recovery configuration verification prompt
Skip to step 8
If you do not see the disaster recovery configuration
verification prompt
Go to step 5