Symantec Veritas Cluster Server One, Installation Manual

Page: 112 / 210

112 Adding a new or replacement system to the Policy Master cluster
Adding a system to the Policy Master cluster
2 Check to see that the new system is up and running. Enter the following:
# /opt/VRTSvcsone/bin/haadmin -switch PMSG -to system1
Replacing a system in the VCS One Policy Master cluster
If you are replacing a faulted Policy Master cluster system, you may restore the
existing authentication service configuration and use it to configure
authentication service on the new system.
The instructions in this section assume the following:
■ You have a Policy Master cluster with two nodes, system1 and system2.
■ Your system1 is faulted.
■
You are replacing system1 with another node (named system1).
The steps for adding a system may vary, depending on your configuration.
To replace a system on the VCS One Policy Master cluster
1 Edit the VCS configuration file, main.cf. Enter the following:
# /opt/VRTSvcs/bin/haconf -makerw
2 Remove the faulted system, system1. Enter the following:
# /opt/VRTSvcs/bin/hagrp -modify PMSG SystemList -delete
sys1
# /opt/VRTSvcs/bin/hagrp -modify VCShmg SystemList
-delete sys1
# /opt/VRTSvcs/bin/hasys -delete sys1
3 Add the replacement system, system1. Enter the following:
# /opt/VRTS/install/installvcsonepm -addnode
4 Write the changes to the configuration file, main.cf. Enter the following:
# /opt/VRTSvcs/bin/haconf -dump -makero
5 Check the status of your Policy Master cluster. Enter the following:
# /opt/VRTSvcsone/bin/haadmin -state
6 Check to see that the new system is up and running. Enter the following:
#
/opt/VRTSvcsone/bin/haadmin -switch PMSG -to system1