Symantec Veritas Cluster Server One, Installation Manual

Page: 47 / 210

47 Installing and configuring the VCS One Policy Master
Configuring the Policy Master
Entering the NICs for the Policy Master virtual IP address
To enter the NICs for the Policy Master virtual IP address
1 Enter the NIC for the Policy Master Virtual IP address to use on your system.
From the list of NIC devices that are discovered on your systems, select any
NIC that is up and running on a public network. For example, enter the
following:
■
(On Linux)
eth0
■ (On Solaris x64)
bge0
2 At the all nodes prompt, specify if you want to use the same NIC on all Policy
Master systems. Do one of the following:
■ To use the same NIC on all Policy Master systems, enter
y
.
■ To select your NICs one-by-one for each Policy Master system, enter
n
.
Specifying whether to use the mpathd (Solaris only)
If you install on Solaris, you must indicate if you want to use the
mpathd
that the
operating system provides.
To specify whether to use the mpathd
1 At the mpathd prompt, do one of the following:
■
If you want to use the mpathd, enter
y
.
Then go to step 2 .
■ If you do not want to use the mpathd, enter
n
.
Then go to the next section, “ Choosing a storage architecture to
configure .”
2 If you use the mpahtd, enter its absolute path. For example, enter the
following:
/sbin/in.mpathd
Entering the Policy Master virtual IP addresses and netmasks
To enter the Policy Master virtual IP addresses and netmasks
1 Enter one or more Policy Master virtual IP addresses. For example, enter the
following:
192.168.1.20 192.168.1.21
2 Enter the netmasks for the virtual IP addresses you entered. Review the
information. For example, enter the following:
255.255.248.0
.
3 At the Policy Master configuration verification prompt, confirm that the
virtual IP addresses, netmasks, and NICs are correct. Enter the following:
y
.