Symantec Veritas Cluster Server One, Installation Manual

Page: 46 / 210

46 Installing and configuring the VCS One Policy Master
Configuring the Policy Master
4 At the low priority heartbeat prompt, specify if you want to configure a low
priority heartbeat link. Type
y
or
n
.
5 If you configured a low priority heartbeat, enter the NIC. For example, enter
the following:
■
(On Linux)
eth2
■ (On Solaris x64)
bge2
Type
y
to confirm the NIC entry.
6 At the all systems prompt, specify if you want to use the same NICs for
private heartbeat links on all systems. Type
y
or
n
.
Specifying the authentication services port number
You must specify if you want to use the default port number for authentication
services.
To specify the authentication services port number
◆
At the authentication services port number prompt, do one of the following:
■ If you want to use the default port number (14159) for authentication
services, enter the following:
y
.
■
If you want to specify a different port number for authentication
services, enter the following:
n
. At the next prompt, enter the port
number you want to use. For example, enter the following:
14001
.
Confirming the Policy Master cluster configuration
At the cluster configuration verification prompt, verify that the name, ID,
broker port, and NIC information is correct.
(The broker port is the authentication services port number you set in the
section “
Specifying the authentication services port number .” )
To confirm the Policy Master cluster configuration
◆
At the Policy Master cluster configuration verification prompt, confirm that
the configuration information is correct. Enter
y
.
Configuring virtual IP addresses for the Policy Master
You must enter the NICs for the Policy Master virtual IP address. If you install
on Solaris, you must specify if you want to use the mpathd. You must also enter
the Policy Master virtual IP addresses and netmasks.