Suzhou Monarch Control Technology MCTC-CTB-A, User Manual, Page: 157 / 183

NICE3000 User Manual System typical application and adjustment
157
(Generally the default can meet the requirements).
Test at low speed (inspection speed) 5)
After complete the operations above, we can try to run the car at low speed (inspection speed).
The speed is setting by F3-11.
Check input signal: view carefully whether the action sequence of the switch signals a)
received in the travel proceeding is correct or not.
Check output signal: view carefully whether the definition of MCB ,NICE 3000 output b)
terminal is correct and work of that is normal, and whether the signal and the contact
controlled by MCB output terminal work well.
Check run direction: place the car at non-end floor and start low sped running, view c)
whether the actual direction is the same with the aimed direction; if not, please
exchange two phases of motor
’
s three phases randomly.
Check encoder: if the speed is abnormal, swing when travel, the output current is too d)
great or abnormal noise, please check connection of encoder, and exchange phase A,
phase B
Check communication: view whether the communication indicate lamp COP, HOP are e)
normal.
7.1.3 Adjusting on the high speed running lift
Before adjust at high speed, please confirm that up and down force reducer switch, end switch,
limited switch act correctly, leveling flashboards are installed correctly; action sequence of
leveling inductor is correctly. Connection of encoder is correct; F1-12 pulse number per rotation
of the encoder is setting correctly.
Check before high speed 1)
There
’
s some interval between adjustment at low speed and that at high speed. a)
Please repeat the check before testing at low speed.
Confirm the connection of car top board. b)
Connection of CAN communication and external calling is correct, and the voltage is c)
24V
±
15%.
Confirm that force reducer switch, end switch, limited switch are installed correctly, and d)
act reliably.
Confirm that each switch act reliably. e)
Confirm the connection of light-beam is correct. f)
Confirm that leveling inductor
’
s connection is correct, and leveling plate is installed g)
correctly.
Confirm that the connection of talking device is correct, and work normally. h)
Confirm connection of arrival gong i)
Confirm the connection of car illumination and fan. j)