Suzhou Monarch Control Technology MCTC-CTB-A, User Manual, Page: 145 / 183

NICE3000 User Manual Function parameter description
145
6.14 FD Group Communication Parameters
Function code Name Setting Range Default Min. Unit
FD-00 Baud rate setting
0
：
300bps
1
：
600bps
2
：
1200bps
3
：
2400bps
4
：
4800bps
5
：
9600bps
6
：
19200bps
7
：
38400bps
5 1
FD-01 Data format
0: No check-out
1: Even check-out
2: Odd check-out
0 1
FD-02 Local address
0
～
127
，
0
：
Broadcasting address
1 1
FD-03 Responding delay 0
～
20ms 10ms 1ms
FD-04
Communication
delaying time
0.0
～
60.0s
，
0.0s
：
invalidation
0.0s 0.1s
This group function codes can set NICE3000 RS232 Serial communication parameter for up bit
motor monitoring software communication. FD-00 sets Serial communication baud rate, FD-01
sets Serial communication data frames format, and FD-02 sets the local address of controller.
These parameters
’
setting must be the same with the Serial communication parameters of
controller so that they can communicate normally. FD-03 sets the delaying time of controller
transmitting data by the Serial port. FD-04 sets the overtime of the Serial port communication,
and the time of frame data transmitted must be within the time of FD-04 setting. Otherwise
communication error may occur.
6.15 FE Group Lift Function Setting Parameters
FE-00
Collective selective mode Default 0 Min. Unit 1
Setting Range 0
、
1
、
2
0
：
Full selective, lift responds to up call and down call.
1
：
Down selective, lift only responds to hall down call and doesn
’
t respond to hall up call.
2
：
Up selective, lift only responds to hall up call and doesn
’
t respond to hall down call.