Sun Microsystems Netra CT 410, Service Manual

Page: 35 / 296

2-1
C H A P T E R
2
Powering the Server Off and On
This chapter provides instructions on powering the Netra CT server on and off. This
chapter contains the following topics:
■
Section 2.1, “Powering On the Server” on page 2-2
■
Section 2.3, “Powering Off the Server” on page 2-7
Note –
Whenever you reboot or power your server on and off, the hot-swap states
revert back to the default full hot-swap state for all I/O slots. If you want basic hot-
swap on an I/O slot, you must manually reset the I/O slot to basic hot-swap after
rebooting or powering your server on and off.
Note – You can also power the Netra CT server on and off through the alarm card
using the
poweroff
and
poweron
commands. Refer to the Netra CT Server System
Administration Guide for more information.