Sun Microsystems Netra CT 410, Service Manual

Page: 65 / 296

Chapter 4 Troubleshooting the System 4-15
Output similar to the following is displayed, giving you the values currently set for
the
Apost
test on the alarm card:
Some values are hard-set and cannot be changed by a user, while others can be
changed to make the test more or less thorough. To change the value for a test, enter
the following command:
where command is the name of the command that you want to change, and value is
the value you want to change.
The following table lists the
Apost
tests that can be changed by a user and the
allowable values for each. Any tests not listed in
TABLE 4-6
are either hard-set and
cannot be changed, or should not be changed by a user.
diag-switch False
verb-mode True
stop-on-error False
diag-level Max
mfg-mode Off
hdr-checksum 0xaa
time-stamp 0
record-format-ver 49
post-version 02
reset-status 0xd0000000
post-status ...
post-msg Watchdog Reset-------- POST Passed-------------------
hostname
cli> diagconf -s
command value
TABLE 4-6
Apost
Tests and Values through
diagconf
Command Value
diag-switch • True—Turns the
diag-switch
test on.
• False—Turns the
diag-switch
test off.
verb-mode • True—Turns the
verb-mode
test on.
• False—Turns the
verb-mode
test off.
stop-on-error • True—Stops the Apost testing when the first error is encountered.
• False—Continues Apost testing, regardless of the number of
errors encountered.
diag-level • Off—Turns the
diag-level
test off.
• Min—Sets the
diag-level
test to the minimum level of testing.
• Max—Sets the
diag-level
test to the maximum level of testing.