Sun Microsystems Netra CT 410, Service Manual

Page: 269 / 296

Appendix B Connecting a Terminal Console to a Server B-3
2. Access the “Set Up Menu” of the ASCII terminal and bring up the Serial
Communications section.
3. Set up the serial port communications parameters.
The default settings should match the values reported on the host serial port.
■
Hardwired modem connection
■
No parity
■
9600 baud
■
1 stop bit
■
8-bit data
4. Test the connection.
Verify that communication is established to the server and the keyboard/display of
the ASCII terminal.
TABLE B-2
Connecting an ASCII Terminal to an Alarm Card or Alarm Rear Transition Module
Server
Type
COM 1 Port on Netra CT Server Adapter Cable Adapter
Serial
Port on
Terminal
Netra
CT 810
server DB-9 male on the alarm rear transition
module. See
Section A.5, “Alarm Rear
Transition Module” on page A-52 .
Not needed DB-9
female-to-
DB-25 male
straight-
through DB-25 female-
to-DB-25
female gender
changer DB-25
male
Netra
CT 410
server DB-9 male on the alarm rear transition
module. See
Section A.5, “Alarm Rear
Transition Module” on page A-52 .
Not needed DB-9
female-to-
DB-25 male
straight-
through DB-25 female-
to-DB-25
female gender
changer DB-25
male