Sun Microsystems Netra CT 410, Service Manual

Page: 117 / 296

Chapter 6 Removing and Replacing Hot-Swappable Boards 6-19
15. Connect the board with the
cfgadm
dynamic reconfiguration software:
where ap_id is the attachment-point ID. For example, to connect the board in slot 4,
as superuser, enter:
16. Activate the board with the
cfgadm (1m)
utility:
where ap_id is the attachment-point ID. For example, to activate the board in slot 4,
as superuser, enter:
17. Locate the LEDs on the system status panel for the board that you just inserted.
FIGURE 6-8
shows the LEDs on the Netra CT 810 server and
FIGURE 6-9
shows the
LEDs on the Netra CT 410 server.
18. Determine if the board is activated.
For detailed information on states of the system status panel LEDs, see Section 4.1,
“Troubleshooting the System Using the System Status Panel” on page 4-2 .
19. If the board activates successfully, perform any necessary board-specific software
configuration.
■
For the alarm card, access the alarm card and perform any appropriate software
procedures, such as updating the alarm card flash. Refer to the
Netra CT Server
System Administration Manual for information.
■
For any other board, perform any necessary board-specific software commands.
Refer to the documentation that you received with the board for any board-
specific procedures.
20. Connect the cables to the board.
Tighten the screws on the cable to a torque of 0.23 N.m (2 in.-lb).
# cfgadm -c connect
ap_id
# cfgadm -c connect IO-4
# cfgadm -c configure
ap_id
# cfgadm -c configure IO-4