Sun Microsystems Netra CT 410, Service Manual

Page: 152 / 296

7-14 Netra CT Server Service Manual • February 2007
6. If you installed a DAT drive into your server, enter the following command to
rebuild the device tree:
This command is not necessary if you installed a DVD drive into your server.
7. Verify that the removable media drive is activated.
As superuser, enter:
■
If you installed a DVD drive in your server, output similar to the following is
displayed:
Locate the line with the attachment point
c0::dsk/c0t6d0
listed in the Ap_Id
column. Verify that the following entries appear for the DVD drive that you
just installed:
■
If you see
CD-ROM
in the Type column and
configured
in the Occupant
column, then the DVD drive is activate. Skip to Step 8 .
■
If you see unavailable instead of
CD-ROM
in the Type column and unconfigured
instead of
configured
in the Occupant column, then the DVD drive is not
activate. Enter the following command to activate the DVD drive:
Enter the
cfgadm -a c0
command a second time to verify that the DVD
drive is activate. Also, you can use the removable media module (RMM)
LEDs on the system status panel to verify that the removable media drive is
activate. When the Okay to Remove LED (
) on the system status panel
for the removable media drive is OFF, the removable media drive is activate.
Continue with
Step 8 .
# devfsadm -i st
#
cfgadm -a c0
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 disk connected configured unknown
c0::dsk/c0t6d0 CD-ROM connected configured unknown
c0::rmt/0 unavailable connected unconfigured unknown
c0::dsk/c0t6d0 CD-ROM connected configured unknown
# cfgadm -c configure c0::dsk/c0t6d0