Sun Microsystems Netra CT 410, Service Manual

Page: 116 / 296

6-18 Netra CT Server Service Manual • February 2007
FIGURE 6-11
Tightening the Ejection Lever Captive Screws
Note – If you are hot-swapping an alarm card, it might take several minutes before
the amber Okay to Remove LED goes off and the alarm card prompt comes up. Do
not proceed until the alarm card prompt comes up.
12. Log into the Netra CT server.
See Section 5.2.1, “Logging In to the Netra CT Server” on page 5-5 .
13. Determine the hot-swap state for the slot that holds the board you just installed.
To determine the current hot-swap state for the slots in your server, as superuser,
enter:
14. Identify the attachment-point ID that corresponds to the slot where you inserted
the board.
As superuser, enter:
# prtconf -v -P
# cfgadm