Sun Microsystems Netra CT 410, Service Manual

Page: 105 / 296

Chapter 6 Removing and Replacing Hot-Swappable Boards 6-7
4. If you are installing a Netra CP2140 host CPU board into a Netra CT server,
ensure that the switch settings on the SW0501 switches are set for the default, non-
high-availability settings. The Netra CT server supports high-availability hot-swap;
however, because the alarm card controls the high availability on the Netra CT
server, the settings on the SW0501 switches on the Netra CP2140 host CPU board
must be set in the default, non-high-availability settings.
Following are the correct settings for the SMC module switch SW0501 for the Netra
CT server (see
FIGURE 6-3
and
FIGURE 6-4
):
■
Switch 1—Closed (switch is set in direction of arrow)
■
Switch 2—Closed (switch is set in direction of arrow)
FIGURE 6-3
Location of SW0501 on SMC Module
FIGURE 6-4
Switch SW0501 in Closed Position (Default) for the Netra CT Server
SMC module
34
SV4
9J
12
12
SV2
8F
SW2401
SW1801
12
SV2
8F
12
SV2
8F
SW0501
1 2