Sun Microsystems Netra CT 410, Service Manual

Page: 155 / 296

8-1
C H A P T E R
8
Removing and Replacing Hot-
Swappable Subassemblies
This chapter contains procedures for the installation, removal, and replacement of
hot-swappable Netra CT server subassemblies. This chapter contains the following
topics:
■
Section 8.1, “System Status Panel” on page 8-2
■
Section 8.2, “System Controller Board” on page 8-6
■
Section 8.3, “Air Filters” on page 8-10
■
Section 8.4, “Power Supply Unit” on page 8-13
■
Section 8.5, “Fan Trays” on page 8-17
Consult the Netra CT Server Safety and Compliance Manual for safety information prior
to performing the procedures in this chapter.
Caution – If you are powering on your Netra CT server, do not remove or install
any components in the system until you verify that the system is completely
powered up. See
Section 2.2, “Verifying Full Power-Up” on page 2-6 for more
information.
Note –
When removing a hot-swappable component, allow several seconds before
inserting it or another component in that slot. Rapidly removing and inserting any
hot-swappable component might panic or hang the system.
Note –
Read Chapter 3 before performing the procedures in this chapter.