Sun Microsystems Netra CT 410, Service Manual

Page: 161 / 296

Chapter 8 Removing and Replacing Hot-Swappable Subassemblies 8-7
FIGURE 8-6
Locating the System Controller Board LEDs on the System Status Panel
(Netra CT 810 Server)
FIGURE 8-7
Locating the System Controller Board LEDs on the System Status Panel
(Netra CT 410 Server)
2. Remove the system status panel as described in Section 8.1.1, “Removing the
System Status Panel” on page 8-2 .
Do not remove the antistatic wrist strap after you remove the system status panel.
Caution – You must remove the system status panel before you access and hot-swap
the system controller board. (This process allows the hot-swap to occur without
causing the host CPU board to go offline and require a reset.)
3. Pull down on the ejection lever to unseat the system controller board (
FIGURE 8-8
).
System controller board LEDs
System controller board LEDs