Sun Microsystems Netra CT 410, Service Manual

Page: 97 / 296

Chapter 5 Hot-Swap Software Commands 5-9
Reactivating a Hot-Swappable FRU
To connect an I/O board, as superuser, enter:
where ap_id is the attachment-point ID.
To activate an I/O board, as superuser, enter:
where ap_id is the attachment-point ID.
5.2.3.3 Enabling Full Hot-Swap on I/O Slots
If you changed the hot-swap states for one or more I/O slots from the default full
hot-swap setting to the basic hot-swap setting, use the
cfgadm
utility to change the
I/O slots back to the default full hot-swap setting.
To enable full hot-swap for an I/O slot in a Netra CT server, as superuser, enter:
where ap_id is the attachment-point ID of the slot that you want to have full hot-
swap enabled on. For example, to enable full hot-swap for I/O slot 4, as superuser,
you could enter the following:
To enable full hot-swap on all slots at once, reboot the server, which automatically
reverts settings back to the default full hot-swap for all I/O slots.
# cfgadm -c connect
ap_id
# cfgadm -c configure
ap_id
# cfgadm -x enable_autoconfig
ap_id
# cfgadm -x enable_autoconfig IO-4