Sun Microsystems Netra CT 410, Service Manual

Page: 127 / 296

Chapter 6 Removing and Replacing Hot-Swappable Boards 6-29
FIGURE 6-20
Aligning the Module with the Rear Cage Cutouts
4. Using a No. 2 Phillips screwdriver, tighten the two captive screws inside the
module’s ejection levers, one on top and one on the bottom (
FIGURE 6-11
).
Tighten the screws to a torque of 0.28 N.m (2.5 in.-lb).
5. Make the necessary cable connections to the host rear transition module.
Tighten the screws on the cable to a torque of 0.23 N.m (2 in.-lb).
FIGURE 6-16
and
FIGURE 6-17
show the connectors on host rear transition modules.
6. After you replace the host CPU rear transition module, get the replacement host
CPU board from the shipping kit.
7. Go to the front of the server and install the replacement host CPU board.
See Section 6.1.2.2, “Inserting a Board” on page 6-15 for instructions.