![background image](http://html1.mh-extra.com/html/stihl/ts-700-ts-800/ts-700-ts-800_service-manual_1379632048.webp)
47
TS 700, TS 800
:
Remove the flywheel (1).
376RA107 TG
1
:
The flywheel (1) and magnet
poles (2) must not display any
signs of damage or discoloration,
otherwise the flywheel must be
replaced.
– Degrease the crankshaft stub
and bore in the flywheel hub with
2
1
376ET108TG
standard solvent-based
degreasant not containing any
chlorinated or halogenated
hydrocarbons,
– Reassemble parts in reverse
order.
:
Ensure that the groove (arrow)
lines up with the machined key on
the crankshaft stub.
– Adjust the distance between
ignition module and flywheel,
376RA132 TG
– Reassemble remaining parts in
reverse order.
Check the short circuit wire if the
spark plug and ignition lead with
spark plug boot are in order.
:
Pull the short circuit wire (1) off
the tag on the ignition module.
1
376RA369 TG
– Connect the ohmmeter to ground
(arrow) and the short circuit
wire (1).
– Set the master control lever
(switch shaft) to "
$
".
The resistance measured must be
about 0
Ω
. If it is much higher, the
reason is a break in the wire and it
must be replaced,
– Set the master control lever
to "
#
".
The resistance measured must be
infinitely high, otherwise fit a new
short circuit wire,
If no fault can be found, carry out
further checks:
– Check the flywheel,
– Check the air gap between
flywheel and ignition module,
– If neither of these checks reveals
a fault, install a new ignition
module,
– Reassemble parts in reverse
order.
8.6
Short circuit wire
8.6.1
Testing