17
TS 700, TS 800
– Align the deep groove ball
bearings with the closed sides
facing outwards.
:
Slide the first deep groove ball
bearing (1), the ring (2) and the
second deep groove ball
bearing (3) onto the shaft.
1
2
3
376RA019 TG
:
Position the deep groove ball
bearings and press them home
with the drift pin (1)
4224 893 7200 until they make
contact with the circlip.
– Draw the assembly pin out of the
deep groove ball bearings.
1
376RA007 TG
– Fit the second circlip in the
groove in the bearing.
Note:
The seal on the deep groove ball
bearing must not be damaged.
:
Lay the washer (1) over the
bearing.
– Insert the bearing in the rubber
bearing from the outside.
1
376RA008 TG
:
Lay a washer over the flange.
– Insert the flange from the inside.
Note:
The rubber rings must also be
aligned with the contours of the
guard.
338RA022 VA
:
Slide the sleeve (1) and spring (2)
onto the screw (3).
– Insert and tighten down the
screws.
338RA023 VA
2
1
3
– Slide the washer onto the shaft
and fit the key.
:
Slide the belt pulley (1) onto the
shaft with the longer collar
(arrow) first.
– Fit the washer and nut, screw the
1
376RA002 TG
nut down tightly.
– Tightening torques,
:
Fit the thrust washer so that the
groove (arrow) is aligned with the
lug.
– Fit the axial clamping ring.
338RA025 VA