81
TS 700, TS 800
:
Screw on nuts (arrows) and
tighten them down until the test
flange lies completely flush
against the carburetor.
376RA372 TG
:
Turn the lower lever
anticlockwise until the rod (1) is
securely pressed against the
upper end of the oblong hole in
the lever (arrow).
1
376RA223 TG
The lever (1) must not be at the top
dead centre = TDC.
:
Press the air flap shut with a
suitable blunt tool (arrow) and
hold it shut.
:
Align the lower lever (1) in
1
OT
2
A
376RA373 TG
accordance with position (A) so
that the rod (2) is vertical.
– Press the lever (1) onto the
ribbed part of the air flap shaft.
The air flap lever is now fixed in
position.
:
Insert the screw (1) and tighten it
down.
1
376RA225 TG
– Wind the leg spring (1) roughly
one turn anticlockwise to tension
it.
:
Hook the leg spring (1) into the
elbow connector (arrow).
1
376RA224 TG
– Check correct functioning.
:
Throttle shutter (arrow) and air
flap (arrow) must be horizontal in
full throttle position.
When the throttle shutter opens, the
air flap opens with a delay equal to
376RA382 TG
roughly one-third of the throttle
shutter opening.
– Reassemble parts in reverse
order.