64
TS 700, TS 800
:
Slide the switch shaft (1) into the
left-hand bearing (arrow) on the
tank housing and then place it in
the right-hand bearing.
1
376RA231 TG
:
Slide the stub of the bearing (1)
into the opening in the leaf spring
(arrow) and fit it over the stub of
the switch shaft (2).
– Press the bearing with switch
shaft downwards.
1
2
376RA232 TG
– Insert the screw in the bearing.
– Tightening torques,
– Check correct functioning.
– Reassemble remaining parts in
reverse order.
– Remove shroud,
– Remove the air filter,
– Remove the air filter base,
Removing the throttle trigger
:
Push the throttle rod (1) down
and out of the throttle trigger (2).
1
2
376RA181 TG
:
Drive out the e-clip (1) with a
suitable tool.
Note:
The e-clip may pop out as it is
removed.
1
376RA180 TG
:
Drive out the axle pin (1) and
remove the washer (2).
1
2
376RA184 TG
:
Unhook the torsion spring (1)
from the throttle trigger (arrow).
1
376RA185 TG
:
Unhook the throttle trigger (1)
from the interlock lever and
remove it from the handle of the
tank housing.
1
376RA186 TG
11.2
Throttle trigger / interlock
lever