36
TS 700, TS 800
– Align the assembly tool so that
the edge number 19 is at the
bottom.
:
Insert four M5x72 screws
(arrows) in the holes marked "19"
and tighten them down against
the drilled plate.
:
Turn the spindle (1) anticlockwise
until the ignition-side half of the
crankcase is pulled off the
crankshaft.
– Remove the gasket from the
crankcase.
1
376RA095 TG
Note:
Assembly tools without holes
marked "19" can be reworked as
illustrated.
The diagram shows the drilled plate
as seen from below.
15,2
48,0
35,4
35,3
3,6
41,8
41,8
15,2
376RA097 TG
:
Drive the crankshaft (1) out of the
crankcase half on the clutch side.
1
376RA101 TG
:
The crankshaft (1), connecting
rod (2) and needle bearing in
between are an inseparable unit.
They must always be replaced as
a complete unit.
Note:
The deep groove ball bearings and
1
2
376RA100 TG
oil seals must always be replaced
when installing a new crankshaft.
:
Remove the oil seal on the
ignition side with a suitable
punch.
376RA1
12 TG
:
Drive the deep groove ball
bearing on the ignition side out
towards the inside of the
crankcase with press arbor (1)
4119 893 7205.
1
376RA1
13 TG
:
Remove the oil seal on the clutch
side with a suitable punch.
376RA1
14 TG