53
TS 700, TS 800
If the action of the starter rope
becomes very stiff and the rope
rewinds very slowly or not
completely, it may be assumed that
the starter mechanism is in order
but plugged with dirt. At very low
outside temperatures, the
lubricating oil on the rewind spring
may thicken and cause the spring
windings to stick together. This has
a detrimental effect on the function
of the starter mechanism.
Cleaning
To clean the rewind spring, it is
sufficient to apply a few drops of a
standard solvent-based degreasant
not containing any chlorinated or
halogenated hydrocarbons to the
rewind spring.
Carefully pull out the starter rope
several times and allow it to rewind
until its normal smooth action is
restored.
If clogged with dirt or pitch, the
entire starter mechanism, including
the rewind spring, must be removed
and disassembled. Take particular
care when removing the spring.
Clean all components,
Before installing, lubricate the
rewind spring and starter post with
STIHL special lubricant,
:
Take out the screws (arrows).
376RA020 TG
:
Take the starter cover (1) and pull
it out to the back (arrow).
– Reassemble parts in reverse
order.
– Tighten down the screws.
1
376RA021 TG
– Tightening torques,
– Remove the starter cover,
:
Carefully ease the spring (1) off
the starter post.
1
376RA314 TG
:
Remove the pawls (1) from the
rope rotor.
– Grease the pegs (arrow) of the
new pawls,
– Reassemble parts in reverse
order.
1
1
376RA316 TG
9.
Rewind starter
9.1
General
9.2
Removal / installation
9.3
Pawls