82
TS 700, TS 800
– Remove the carburetor,
– Remove the choke lever from the
carburetor,
Sealing rings, choke shaft
:
Remove the circlip (arrow) with a
suitable tool.
– Remove the sealing ring (1),
1
376RA274 TG
:
Pull the ring (1) and sealing
ring (2) off the choke shaft.
– Examine the sealing ring and
replace it if necessary.
1
2
376RA275 TG
The choke shaft must be removed
and cleaned,
12.3.5, if its guides
are severely fouled.
– Reassemble parts in reverse
order.
Sealing rings, air flap shaft
– Sealing ring (1) can only be
removed after removing the air
flap shaft,
– Remove the sealing ring (2),
The air flap shaft must be removed
2
1
376RA279 TG
and cleaned,
12.3.7, if its guides
are severely fouled.
– Adjust the air flap rod if
There are three adjusting screws on
the carburetor:
H
= High speed screw (1)
L
= Low speed screw (2)
LA
= Idle speed screw (3)
If the carburetor setting can no
longer be adjusted, this may also be
1
2
3
376RA248 TG
due to the adjusting screws.
Note:
Only the high speed screw has a
limiter cap; a new cap must always
be used after dismantling the high
speed screw.
Remove shroud,
Refer also to troubleshooting on the
carburetor,
Low speed screw
:
Take out the low speed screw (1).
1
376RA249 TG
12.3.10 Sealing rings of choke
and air flap shaft
12.3.11 Adjusting screws