73
TS 700, TS 800
:
Lay the gasket (1) and pump
diaphragm (2) on the end cover.
:
The gasket and diaphragm are
secured in position on the end
cover by the pegs (3).
– Position the end cover with fixed
2
3
3
1
376RA209 TG
gasket and pump diaphragm on
the carburetor body.
– Gently move the end cover back
and forth until the pegs on the
end cover are lined up with the
holes in the carburetor body.
– Insert and tighten down the
screws.
– Tightening torques,
– Remove the carburetor,
If actuation of the choke shaft is stiff
and/or the choke shutter cannot be
opened or closed properly:
– Remove the choke shaft, then
376RA281 TG
clean the shaft and shaft guides
with a little standard solvent-
based degreasant not containing
any chlorinated or halogenated
hydrocarbons.
Severely contaminated O-rings on
the choke shaft must be replaced.
:
Remove the screw (arrow) from
the choke shaft.
376RA282 TG
:
Pull the choke shutter (1) out of
the slot in the choke shaft.
1
376RA283 TG
:
Remove the circlip (arrow) with a
suitable tool.
Note:
The spring on the choke shutter
may pop out when the circlip is
removed.
376RA276 TG
12.3.5 Choke shaft / choke
shutter