35
TS 700, TS 800
:
Position the piston rings so that
the radii at the ring gaps meet at
the fixing pins (arrows) in the
piston groove.
:
Check the correct installed
position of the piston rings again
(arrows).
376RA079 TG
– Install the piston,
– Drain the fuel tank.
Note:
Fuels must be disposed off as
specified by regulations.
– Expose cylinder,
– Remove ignition module if
necessary,
– Remove the flywheel,
– Remove the clutch,
– Remove the cylinder and piston,
:
Remove the screws from the
recesses (arrows) in the two
halves of the crankcase.
376RA092 TG
:
Remove the caps (1) from the
rubber buffers.
– Replace the rubber buffers,
1
1
376RA093 TG
:
Unscrew the rubber buffers
(arrows).
:
Pull the hose (1) off to the back.
1
376RA094 TG
:
Disconnect the impulse hose (1)
from the fan-side half of the
crankcase.
1
376RA091 TG
– Adjust the spindle (1) of the
assembly tool 5910 893 2102
(left-hand thread) so that it can be
centred over the crankshaft stub.
1
19
19
19
19
19
376RA099 TG
7.8
Crankcase / crankshaft
7.8.1
Removal