![background image](http://html1.mh-extra.com/html/stihl/ts-700-ts-800/ts-700-ts-800_service-manual_1379632026.webp)
25
TS 700, TS 800
– Remove the shroud, see
:
Remove screws from the muffler
(arrows).
– Remove the muffler.
376RA047 TG
:
Mount flange (1) 4224 893 2501
on the cylinder exhaust port and
screw in the screws (arrows) half-
way.
:
Slide the sealing plate (2)
0000 855 8106 between flange
and cylinder exhaust port and
2
1
376RA048 TG
tighten down the two screws
(arrows).
Note:
The sealing plate must fill the full
width between the screws.
– Remove the carburetor,
– Set the piston to the top dead
centre. This can be checked
through the inlet port.
:
Check that the sleeve (1) is
present in the manifold.
1
376RA049 TG
:
Check that the pin (1) and sealing
ring (2) have been fitted on test
flange 4224 890 1200, or fit them
if necessary.
1
2
376RA050 TG
:
Mount test flange (1)
4224 890 1200 instead of the
carburetor.
Important:
The pin must be correctly located in
the impulse hose (2) when fitting the
test flange.
1
2
376RA051 TG
:
Remove the decompression
valve (1), see
1
376RA052 TG
:
Screw in the plug (1)
4221 025 2200 instead of the
decompression valve and tighten
it down securely.
– Check that the spark plug has
been screwed in and tighten it
down securely.
1
376RA053 TG
– Tightening torques,
7.2.1
Preparations