![background image](http://html1.mh-extra.com/html/stihl/ts-700-ts-800/ts-700-ts-800_service-manual_1379632079.webp)
78
TS 700, TS 800
:
Pull the air flap shaft out of the
end cover.
:
Pull the ring (1) and O-ring (2) off
the dismantled air flap shaft.
– Clean the air flap shaft and
guides.
1
2
376RA260 TG
– Examine the air flap shaft for
signs of damage and replace it if
necessary.
– Reassemble parts in reverse
order.
– Check correct functioning and
easy movement.
– Turn the air flap shaft until the flat
side of the shaft faces
downwards.
1
376RA261 TG
:
Use a suitable tool to push the air
flap (1) into the air flap shaft on
the throttle shutter side.
Note:
When fitting the air flap, the marks
(arrow) must be visible as an
indentation and be located behind
the bore.
– Insert the screw on the flat side of
the shaft and tighten it down
moderately.
– Close the air flap and centre it in
the bore of the end cover.
– Tighten the screw (arrow).
376RA256 TG
– Tightening torques,
– Check correct functioning and
easy movement.
– Secure the screw with Loctite,
– Check correct functioning again.
If only the rod (1) has broken, it can
be replaced without removing and
adjusting the two levers (arrows).
1
376RA210 TG
:
Remove the circlip (arrow) with a
suitable tool.
376RA21
1 TG
:
Unhook the rod (1) from the air
flap lever (arrow).
1
376RA212 TG
12.3.8 Air flap rod