Chapter 2 — Installing the nTier500
38
User Guide
90990030
5.
Fit the tabs on one rail extender between the nut plate and one of the
back rack legs. Then, fit the front tabs on the rail between the nut plate
and corresponding legs on the front of the rack. Tighten all three screws
to secure the nut plate to the rack.
6.
Repeat Step 5 to attach the second outer rail to the rack. Set aside any
leftover screws and parts.
7.
On the front of the rack, attach two clip nuts (bag
4
in the rack kit), to
each leg. Place one above and another below the rails, with one empty
hole separating each clip nut from the nut plate mounting screws, as
shown in
Figure 14
.
o
Figure 13
Insert the rail tabs between the nut plate and the rack.
Tabs
Front
(behind post)
Rear
Tabs
o
Figure 14
Attach clip nuts to the front of the rack.
Clip nut
Clip nut
Empty hole
Empty hole
Mounting screws
for nut plate
Summary of Contents for nTier500
