Sony DVS-7300, User Manual

Page: 552 / 606

15-4
Chapter 15 DIAGNOSIS Menu Operations
Displaying Error Messages
You can use the ERROR MESSAGE menu to display error messages for the
switcher and DME connected to the control panel.
To display error messages, use the following procedure.
1
In the DIAGNOSIS menu, select item 5 (ERROR), and then press F3
(ERROR MESSAGE).
The ERROR MESSAGE menu appears.
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
CH2 CH1
PANEL
CH6
[POPUP]
CLEAR CH5
CH4
SWER
PROC
CH3
DMK
PROC
DME PROC
Function key indications in the ERROR MESSAGE menu
If any function key is flashing, it indicates an error has occurred on the
corresponding equipment.
2
Press the flashing function key to display the error message.
To clear the error message if displayed even after correction of
the error
Even after the error is corrected, the error message may remain displayed.
To clear the error message in such a case, press F10 (CLEAR).
If the error is no longer present, the error message will disappear.
To temporarily clear an error message and turn off the alarm
buzzer
When an error is detected causing the corresponding error message to
appear and the alarm buzzer to sound, you can temporarily clear the error
message and turn off the alarm buzzer by holding down the SHIFT button
and pressing F10 (POPUP) in the ERROR MESSAGE menu.
In this case, resetting the control panel before correcting the error will
cause the same error message to appear and the alarm buzzer to sound
again.
Operations