Sony DVS-7300, User Manual

Page: 490 / 606

14-34
Chapter 14 Setup
Setup Relating to Input/Output Signals (INPUT/OUTPUT Menu)
In a 3-M/E system, the effect depends on the final M/E setting. For
example, if M/E-3 is the final M/E, when you select the M/E1 PVW, M/
E2 PVW, or PRESET signal on the EDIT PVW bus, then depending on
the signal which is on air, the output signal from the EDIT PVW bus is
switched as shown in the following table.
If M/E-1 or M/E-2 is the final M/E, then the above table applies, with the
appropriate bank interchanged with M/E-3.
When the AUTO PVW2 setting is “ALL”, the program and preview
outputs are switched in the same way as shown in the table above, not
only on the EDIT PVW bus, but also on the AUX 1 to 8 and ASSIGN
OUT 1 to 5 buses.
To carry out these settings, use the following procedure.
1
In the INPUT/OUTPUT menu, press F7 (OUTPUT ASSIGN).
The OUTPUT ASSIGN menu appears.
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
SIGNAL
SELECT AUTO
PVW SELECT
OUTPUT
SELECT
PVW OUT
SELECT
ASSIGN
OUT
PVW/
KEY
PVW DSBL
AUTO
PVW2
DSBL
AUTO
CLEAN
DSBL #3
DEFINE
PVW
KEY #2
PVW SELECT
Function key indications in the OUTPUT ASSIGN menu
Signal selected on the
EDIT PVW bus Condition Output signal from the
EDIT PVW bus
M/E1 PVW M/E1 on air M/E1 PVW
Not on air M/E1 PGM
M/E2 PVW M/E2 on air M/E2 PVW
Not on air M/E2 PGM
PRESET When the same M/E is
selected on the M/E-3 A
and B buses M/E1 PVW, M/E2 PVW
Other cases M/E3 PVW