Sony DVS-7300, User Manual

Page: 466 / 606

14-10
Chapter 14 Setup
Setting the system configuration (SYSTEM CONFIGURATION
menu)
You can use the SYSTEM CONFIGURATION menu for the following
settings.
• Selecting the system configuration: Select a switcher system
configuration, SEPA (switcher system without including the DMK-7000)
or PAIR (switcher system including the DMK-7000).
Always select PAIR for a 3.5-M/E system.
• Selecting the DMK-7000 configuration: Select a DMK-7000 keyer
configuration, CASCAD (cascade), PARA (parallel), INDPND
(independent), or DUAL (dual cascade).
You cannot select INDPND for a 3.5-M/E system.
• Setting the switcher program output (SWER PGM) (3-M/E systems
only): Select one of the following three signals for output from the
switcher’s PGM OUTPUTS connectors.
M/E-1 PGM (program), M/E-2 PGM, and M/E-3 PGM.
• Setting the final bank controlled from the remote panel: Select which of
the banks controlled from a remote panel connected to the PANEL 2
connector on the main switcher unit is the final bank. The high tally
indications on the remote panel follow this setting.
• Setting the phase relation between the external sync signal input to the
switcher and the switcher and DMK-7000 output signals: Adjust in the
range –28 to +70
µ
s.
When the system configuration is set to PAIR, adjust the switcher and
DMK-7000 outputs to the same phase value.
• Setting the color correction and frame memory function configuration:
When the BKDS-7420 Color Correction Board and BKDS-2041 Frame
Memory Board are both installed, determine how to use them.
• Use the color correction function along with the frame memory
function.
• Use the color correction function alone.
When using the color correction function along with the frame memory
function, determine which function to apply first.
• Apply the color correction function before the frame memory function.
• Apply the color correction function after the frame memory function.
• Multiple cross-point assignment: Set up to five sets of different signal
assignments to cross-point buttons (assignment tables). Also select the
assignment table currently used.
Setup Relating to the Overall Switcher System (SYSTEM Menu)