Sony DVS-7300, User Manual

Page: 491 / 606

Chapter 14 Setup
14-35
2
Carry out the operation in the following table to make the required
setting.
Setting Operation
Output signal selection Use the following procedure.
1 Press F1 (OUTPUT SELECT), and move the cursor
to select the output signal group from SWER CLEAN
(switcher clean output), and DMK CLEAN (DMK-
7000 clean output). (The list of output signals
changes according to the selection.)
2 Press F5 (SIGNAL SELECT), and move the cursor to
select the output signal from the list.
3 Press F3 (SELECT), to confirm the selection of the
output signal.
Switching the preview
output for a switcher M/E
bank or DSK 1 to 4 Use the following procedure.
1 Press F7 (PVW OUT SELECT), and move the cursor
to select the PVW output, to which the subsequent
setting applies, from among M/E-1 to M/E-3 and
DSK1 to DSK4.
2 Press F8 (PVW/KEY).
This cycles the setting through PVW, KEY, and
CLEAN for the M/E, or toggles between PVW and
KEY for the DSK.
Defining the PVW output
of a switcher Use the following procedure.
1 Press F7 (PVW OUT SELECT), and move the cursor
to select the PVW output, to which the subsequent
setting applies, from among M/E-1 to M/E-3 and
DSK1 to DSK4.
2 Press F9 (DEFINE PVW).
This toggles between L-PVW and K-PVW for the
M/E, or cycles the setting through L-PVW, K-PVW,
and F-PVW for the DSK.
Setting the auto clean
function Press F2 (AUTO CLEAN) to toggle between ENBL
and DSBL.
ENBL: The auto clean function is enabled.
DSBL: The auto clean function is disabled.
Auto preview setting Press F4 (AUTO PVW), to toggle between “ENBL” and
“DSBL”.
ENBL: The auto preview function is enabled.
DSBL: The auto preview function is disabled.
Setting the auto preview
2 function Press F10 (AUTO PVW2) to toggle between ENBL
and DSBL.
ENBL: The auto preview 2 function is enabled.
DSBL: The auto preview 2 function is disabled.
(Continued)