Sony DVS-7300, User Manual

Page: 113 / 606

Chapter 4 Basic Operations for Image Creation
4-29
4
If you selected a wipe or DME wipe as the transition type, make the
necessary settings.
For details of the settings, see the sections on the pages indicated in the
following table.
5
Set the transition rate.
For details, see the section “Setting the Transition Rate” (page 4-32).
6
Press the AUTO TRANS button for DSK 1.
This starts the transition, and inserts or removes downstream key 1 at the
prescribed rate.
• The AUTO TRANS button lights amber during the transition, and then
goes off.
• During the transition, while key 1 is present in the output, the DSK 1
ON button lights red or amber.
• To pause the transition while it is in progress, press the AUTO TRANS
button again. The AUTO TRANS button then lights green.
To resume a paused transition, press the AUTO TRANS button once
again. This time the AUTO TRANS button reverts to amber.
Cutting a key in using the KEY ON button
To cut in a key which is already set up, press the corresponding KEY ON
button.
This inserts the key, and the KEY ON button lights.
Cutting a key out using the KEY ON button
To cut out a key which is already inserted in the output, press the
corresponding KEY ON button (which is lit red or amber).
This removes the key, and the KEY ON button goes off.
Wipe “PGM/PST Wipes and Downstream Keyer Wipes” (4-116)
DME wipe “DME Wipe Settings” (4-131)