Sony DVS-7300, User Manual

Page: 120 / 606

4-36
Chapter 4 Basic Operations for Image Creation
Switching from manual to auto transition control
• If you press the CUT button, the transition completes instantaneously.
• If you press the AUTO TRANS button while using the fader lever to control
a transition, auto transition control starts from the transition state
represented by the current fader lever position, and completes the transition
at the set rate (taking a time proportional to the remaining transition).
Non-sync state
If you start a manual transition with the fader lever, then switch to auto
transition, the position of the fader lever no longer agrees with the state of the
transition. This is termed the non-sync state, and in this state the transition
progress indicator appears as shown below, with only the ends (two LEDs)
lit.
In the non-sync state, moving the fader lever has no effect on the transition.
To use the fader lever again, first move it to either end of its range. This
releases the non-sync state, and all LEDs in the transition progress indicator
go off.
Even in the non-sync state, you can press the AUTO TRANS button to carry
out an auto transition. In this case, the indicator shows the progress of the
transition as usual, then when the transition completes, returns to the non-
sync indication.
Non-sync state
Executing a Transition
Two LEDs light at each
end of the indicator