Simrad SC90, Installation Manual

Page: 329 / 544

419050/B
327
Procedure
1 Open the
Installation
menu.
a Select the
Setup
tab to open the menu.
b Select
Test
on the
Setup
menu to open the
System Test
menu.
c Select
Installation menu
to open the menu.
d Observe that the
Installation
menu opens
across the top of the SC90 presentation.
2 On the
Installation
menu, select
Installation
→
I/O
Setup
→
Sensors
.
a On the submenu, select
Speed
.
b Observe that the
Sensor Configuration
parameter dialog box opens.
3 Set up the relevant port parameters.
a Select
Port
to choose which serial port to use.
Note
Serial line 1 (COM1) is used to communicate with the Operating Panel.
b Select
Configure Port
to set up the relevant communication parameters.
c Select
Specify Talker ID
if you wish to specify a specific talker.
d Select
Add Talker
if you wish to use a specified talker value that is not on
the list.
An on-screen keyboard opens automatically.
e Select
Timeout
if you wish to specify a specific time-out value.
f Select
Input
if you wish to specify Auto or Fixed input.
Select
Auto
or
Fixed
to control the functionality. When
Auto
is selected, all
relevant sensors are placed in a preferred list. Information is imported from
the sensor on the top of the list. If the sensor fails to provide information
for more than 20 seconds, data from the next sensor is used. When
Fixed
is
selected, the list is not used. Information is only imported from the chosen
sensor. All other sensors are ignored.
4 Select
Close
to save the settings and close the parameter dialog box.
5 Close the
Installation
menu.
Setting to work