Siemens HiPath 1100, Programming Manual

Page: 150 / 241

Step by step
Digital trunk settings
150
r
w
Press this key.
Initial status for programming mode.
Operation Mode for S
0
Line
This setting specifies the type of connection between
the S
0
Module digital lines and the local carrier. The con-
nection can be Point-to-Point or Point-to-Multipoint or S
0
Bus.
Required:
Programming mode must be activated (*95
31994).
emd
w
Enter the programming code.
de
,
df
, Enter the S
0
module slot on the system
1
.
dg
or
ee
.
p
Enter the physical position of the port on the S
0
module
dd . de
= For the HiPath 1120 (The Position of
the Port 00 is only for the external line - PP or PMP)
dd .dh
= For the HiPath 1150;
dd .dh
= For the HiPath 1190 (For the second
module, place position 11 and port from 00 ... 04).
e
...
g
w
Select the type of connection for the external digital
line.
e
= Point-to-Point (PP - default for the first port)
f
= Point-to-Multipoint (PMP)
g
= Bus S
0
line call (default for all other ports)
p
Key in the physical slot of the port in the S
0
module
or
r
w
Press this key.
Initial status for programming mode.
[1] Module slots are: HiPath 1120 (02), HiPath 1150 (03) and HiPath
1190 (01 and 11).
With the HiPath 1120, the S
0
module’s first port
can only be a digital line, PP or PMP. It cannot be
programmed as an S
0
bus.
With other switches, the first port may also be
configured as an S
0
bus.