Mirror base wire stretching
Refer to "[8] ADJUSTMENTS."
Copy lamp unit attachment position
1
pass the front/rear mirror base drive wires between the copy lamp
unit frame and the wire fixing plate.
At that time, do not tighten the wire fixing screw.
2
Press the copy lamp unit to the positioning plate, and tighten the
wire fixing screw.
@
At this time, allow a clearance of 2 mm between the No. 2/3 mirror
base unit and the projection in the optical section.
No. 2/3 mirror base unit attachment position
This is to adjust the parallelism of the mirror base B with the drum
surface and the original surface.
1
Manually turn the mirror base drive pulley to bring the mirror base
B into contact with the mirror base positioning plate. If the rear
side and the front side of the mirror base B make contact with the
mirror base positioning plate simultaneously, the parallelism of
mirror base B is proper, and there is no need for further adjust-
ment.
Mirror drive wire (mirror base C) replacement
(Mirror base C drive wire removal)
1
Remove the mirror base C drive wire spring and the fixture from
the mirror base.
2
Remove the mirror base C drive wire from the mirror base pulley.
Reverse the above procedures.
(Note) Hook the wire fixture first on the mirror base pin.
F
R
2mm
2mm
A
7 – 13