H RADF (SF-A55)
13. Affix the green label.
Lifting up on the staple sorter’s release lever, separate the sorter from
the copier.
Next, affix the green label to the paper output section handle as
shown in the figure.
Holding the staple sorter’s release lever, return the sorter to its
original position. At this time, confirm that the staple sorter locks
securely into place beside the copier.
Plug the copier’s power cord into an electric outlet, switch on the
power, and then perform the following procedure.
14. Set the mode.
Perform the following key operations on the copier to set the mode.
Performing the above operation will cause the current setting to be
displayed.
SIMULATION No. 26-1
SORTER/STAPLE SORTER SETTING?
1. YES 2. NO
B. Staple sorter operation check
1. Check the sort mode.
Make 20 copies in the sort mode and confirm that the copies are
distributed to the sort bins with no abnormal noises from the sorter.
2. Check the non-sort mode.
Make copies in the non-sort mode and confirm that they are sent to
the non-sort bin.
3. Use the RADF (reversing automatic document feeder)
and check the staple sort mode.
Place 2 or more sheets in the RADF and make copies in the staple
sort mode. Confirm that the copies are distributed to the sort bins,
that the staple guide bar arranges the copies and that the stapler
functions properly.
If at this time the copies have not been stapled or the stapler is
jammed, adjust the staples by performing one of the following proce-
dures.
If copies have not been stapled
1. Remove the staple cartridge.
Open the stapler cover, lift up on the staple cartridge and remove it by
pulling in the direction of the arrow.
2. Check the staple cartridge.
Confirm that the sheets of staples in the cartridge are properly stack-
ed.
If not, slide the staples back in the direction of the arrow while press-
ing in gently on the bottom of the cartridge.
Green label
Staple sorter Paper output section handle
C
2
6
1
3
OR
1
Performing the above operation
will cause the current setting to
be displayed
Staple cartridge
Stepler cover
6 – 25