6
Startup
Parameter description
Operating Instructions – CMP ELVCD
63
Parameter 077.1
Angular encoder configuration
The parameter indicates the configuration (single-turn/multi-turn) of the encoder (re-
solver/sine-cosine encoder).
Parameter 077.2
SINCOS pulses per revolution
The parameter indicates the increments per revolution measured by the sine/cosine
encoder (= 4 x number of sine cycles of the sine/cosine encoder).
Parameter 078.0
Offset rotor position
The parameter indicates the offset of the rotor position in angular degree.
Parameter 078.1
Number of pole pairs
The parameter indicates the number of pole pairs of the motor.
Parameter 079.0
Encoder offset
The parameter indicates the encoder offset in increments.
Parameter 080.0
Signal: Motor overtemperature
The parameter indicates whether the motor temperature is too high.
Parameter 080.1
Signal: Under-/overtemperature of the power electronics
The parameter indicates whether the temperature in the power electronics of the in-
verter is too high or too low.
Parameter 080.2
Signal: SINCOS supply fault
The parameter indicates whether
•
the sine-cosine encoder supply is not present
•
or the encoder is configured incorrectly.
Parameter 080.3
Signal: SINCOS-RS485 communication error
The parameter indicates whether
•
the communication of the sine-cosine encoder is not present
•
or the encoder is configured incorrectly.
22759468/EN – 11/2017
