SELVA MARINE Blue Whale 250 EFI, Service Manual

Page: 77 / 377

6P23H11
3-12
1
2
3
4
5
6
7
8
9
8. Check the gear shift for smooth operation,
check the operation of the neutral switch
and, if necessary, repeat steps 3
– 7.
Bracket unit
3
Checking the PTT operation
1. Fully tilt the outboard motor up and down
a few times and check the entire trim and
tilt range for smooth operation. Check the
PTT fluid level if necessary.
NOTE:
Be sure to listen to the winding sound of the
PTT motor for smooth operation.
2. Fully tilt the outboard motor up, and then
support it with the tilt stop lever
1
to
check the lock mechanism of the lever.
Checking the PTT fluid level
1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever
1
.
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the PTT unit should lose
fluid pressure.
2. Remove the reservoir cap
2
, and then
check the fluid level in the reservoir.
WARNING
Make sure that the trim and tilt rams are
fully extended when removing the reser-
voir cap, otherwise fluid can spurt out
from the unit due to internal pressure.
NOTE:
If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole when the cap is removed.
S6P23190
Control system / Bracket unit